High “stone filling” has resulted in a 3D printer filament with remarkable aesthetic features and a significant higher material density up to 37% higher than “normal” PLA.
StoneFil is an easy-to-print 3D printer filament and printed objects have an extremely matte stone-like finish with unique natural gradient colour linings resulting in an exceptional chromatic spectrum per print. Every StoneFil printed object has its own identity and unique gradient colour shading.
- Easy to print
- 50% gravimetric powdered stone filling
- ±37% heavier than “normal” PLA
- Matte and rough stone-like finish
- Unique natural/organic gradient colour linings
- Every print has its unique natural stone gradient colour shading
StoneFil has a very high filling with stone powders and therefore the filament can have a slightly more abrasive effect on brass nozzles than unfilled filaments. Check out our wear-resistant nozzles.
When printing with filled/composite filaments, it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.
Materials will be exchanged only if products are found to be defective as a result of manufacturing processes.
All exchanges and warranty claims will be on a case-by-case basis. Contact Meka 3D Printing Pte Ltd at firstname.lastname@example.org for claims.
Cancellations and refunds are only done on a case-by-case basis. Contact Meka 3D Printing Pte Ltd at email@example.com for claims.