The Castable Blend Resin is the only option if you are looking to do investment casting.
This resin has been proven to work with standard vacuum investment casting settings and methods - it has worked for casting of bronze, copper, tin and iron.
Works with any light source with a wavelength of 225nm to 415nm - standard for most DLP 3D Printers. The resins also work reliably with some models of SLA printers.
A DLP Printer with a 180 watt lamp will cure a 0.05mm layer in approximately 2 seconds. A 240 watt lamp will cure a 0.05mm layer in half a second. - That is some of the fastest curing times among all the resins in the market.
Super easy to use
Resins come ready to use with pigments already optimised and mixed in. After initial calibration, there is nothing else to worry about. Special formulation has brought down average shrinkage on these resins to approximately 0.5% - the industry average is 3.5%
The resins have a very faint odour and cause minimal skin irritation as compared to other resins.
1. Agitate in a vat of Isopropyl Alcohol (IPA), for 2 minutes to remove excess resin. Use a soft brush if necessary.
2. Clean off any excess IPA with a cold blowdryer or compressed air.
3. Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
Do not soak in IPA or water (the resin is hydrophobic). Do not place in an ultrasonic bath.
Store the resin in a dry, cool and shaded place.