The Industrial Blend Resin is a special formulation for industrial applications. This blend can withstand very low and very high temperatures (tested from -45˚C to 225˚C)- suitable for any test environment.
The Industrial Blend Resin one of the only resins that has been used for vulcanisation.
Works with any light source with a wavelength of 225nm to 415nm - standard on most DLP 3D Printers. The resins also work reliably with some models of SLA printers.
A DLP Printer with a 180 watt lamp will cure a 0.05mm layer in approximately 2 seconds. A 240 watt lamp will cure a 0.05mm layer in half a second. - That is some of the fastest curing times among all the resins in the market.
Super easy to use
Resins come ready to use with pigments already optimised and mixed in. After initial calibration, there is nothing else to worry about. Special formulation has brought down average shrinkage on these resins to approximately 0.5% - the industry average is 3.5%
The resins have a very faint odour and cause minimal skin irritation as compared to other resins.
We have a blend of unpigmented resins should you want to experiment with different colours.
When fully cured the industrial blend resin has a hardness of approximately 75 shore D (what does this mean?). It has also been tested and proven to withstand a myriad of different chemicals including water, acetone, alcohol and thinner. Find out more here.
1. Agitate in a vat of Isopropyl Alcohol (IPA), for 2 minutes to remove excess resin. Use a soft brush if necessary.
2. Clean off any excess IPA with a cold blowdryer or compressed air.
3. Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
Do not soak in IPA or water (the resin is hydrophobic). Do not place in an ultrasonic bath.
Read about other important things to look out for when purchasing resins for your DLP/SLA 3D Printer.
Store the resin in a dry, cool and shaded place.